Product Overview
Brand: LOYALHEARTDY
Features:
- 【Labor-saving Design】Compact size, lightweight, easy to grab. It can save 3-5 times than man power by hand. Reasonable structure, advanced craft, simple and convenient operation, high efficiency and convenient maintenance.
- 【Premium Performance】It is a miniature motor tool has the trait of safety and credibility. Rebar Tier is a hand held machine used to pack rebars quickly.
- 【Multi-function】 Used for building market, including civil building, floor pipe, heating floor mesh, steel bar, etc.
- 【Main Parameters】Voltage: 12V; Battery Capacity: 4500 mAh; Tying Wire Diameter: 0.8mm; Applicable Scope Of Steel Strapping: 8mm - 34mm; Knot Wire Length: 300 - 500mm; Knot The Required Time: 0.8 seconds at a time.
- 【Package Including】1X Tying Machine; 1X Pliers; 1X Charger; 1X Storage Box; 2X Lithium Ion Batteries; 1X Tying Wire in the machine (Tying Wire Standard: About 0.8 mm x 110 m/roll)
Details: Specifications： Material: Plastic + Metal Battery: Lithium Ion Batteries Battery Charging Time: 1.5 hours full filling Tying Wire Diameter: 0.8mm Tying Wire Length: more than 110 m Knot Number Per Charge: 1500 times Machine Size: 275 mm * 65 mm * 240 mm / 10.83''x2.56''x9.45''(appr.) Tool box size: 42cm (16.54inch) *30cm (11.81inch) *10cm (3.94inch) Tying Wire Installations： 1. In the state of start-up, press the locking plate of the opening wire plate, open the plate cover. 2. Take out the tying wire, tear the packaging film, pull straight wire head about 10 cm, load into the binding machine in the clockwise direction, the wire head into the guide tap tube. 3. Insert the head of the wire guide into the tap pipe until it is resisted. 4. Cover the plate and fasten the locking piece. 5. Pinch the wire forward with two fingers, press and hold the switch and send the wire out. 6. If you want to take out the wire plate when finished, press and hold the locking piece, open the wire plate cover plate, holding the wire tray to the side and pull out. Operation Instructions： 1. The rebar tirer's jaws are stuck to the intersection of the steel bars, and the steel bars are hooked at 45 degree angles. Note: There can be no barrier between the mouth of the jaws and the wire. 2. Press the start switch, the rebar tirer machine carries on the work (spins, hinges tightly, cuts off) Note: Press one button at a time, do not probe the jaws at work. 3. When automatic completion, the jaw from the steel bar intersection and then pull back, complete the process and prepare for the next binding. 4. When the binding process is not completed, do not unplug the machine in advance, otherwise it will cause the bundling of the goods tied skidding.
